This shows you the differences between the selected revision and the current version of the page.
| gnucap:manual:commands:transient 2009/12/07 21:07 | gnucap:manual:commands:transient 2009/12/07 21:09 current | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| transient start stop stepsize {options ...} | transient start stop stepsize {options ...} | ||
| transient stepsize stop start {options ...} | transient stepsize stop start {options ...} | ||
| - | |||
| ===== Comments ===== | ===== Comments ===== | ||
| - | The nodes to look at must have been previously selected by the print or plot command. | + | The probes to look at must have been previously selected by the print or plot command. |
| Three parameters are normally needed for a Transient analysis: start time, stop time and step size, in this order. The SPICE order (step size, stop, start) is also acceptable. An optional fourth parameter is the maximum internal time step. | Three parameters are normally needed for a Transient analysis: start time, stop time and step size, in this order. The SPICE order (step size, stop, start) is also acceptable. An optional fourth parameter is the maximum internal time step. | ||